Batik Wax Pelleted

 Material Health & Safety Data Sheet – Revised 10/01/2023

Batik Wax – All Melting Points

1. IDENTIFICATION

Batik Wax, solid slab or pellets.

2. COMPOSITION

A mixture of solid saturated hydrocarbons, molecular formula C_n H_2n+2. Hazardous ingredients: None.

3. HAZARDS IDENTIFICATION

Not classified as hazardous for supply under UK CPL or CHIP Regulations. EC Labelling: None

4. FIRST AID MEASURES

Solid:   None

Liquid: Because it is often used in the molten state at elevated temperatures there is a risk of thermal burns and therefore contact with the skin should be avoided and precautions taken against accidental splashes.

In the event of wax entering the eyes these should be flushed immediately with water for 15 minutes and medical attention obtained.  Molten wax on the skin should be cooled rapidly by cold water and removed carefully from the skin in not less than 30 minutes to avoid blistering, preferably under medical supervision to avoid tissue damage.

5. FIRE-FIGHTING MEASURES

Although not classified as inflammable by the criteria used for transport purposes in the UK, nevertheless this product will burn and in the event of a small fire, foam, carbon dioxide, dry chemical powder, sand or earth may be employed; for large fires use foam or water fog.

Carbon Monoxide (CO), Carbon Dioxide CO₂ smoke.

6. ACCIDENTAL RELEASE MEASURES

7. HANDLING & STORAGE

No special measures necessary if used correctly.

Solid wax can be stored for indefinite periods in paperboard boxes, woven polypropylene bags or cartons on pallets away from possible sources of contamination and in cool, dry conditions.

8. EXPOSURE CONTROLS/PERSONAL PROTECTION

Adequate personal protective equipment must be worn when handling wax in molten state.

9. PHYSICAL & CHEMICAL PROPERTIES

Practically insoluble in cold water, sparingly soluble in organic solvents in the cold, but quite soluble hot.  Low chemical reactivity.  Incompatible with strong oxidisers.

10.STABILITY & REACTIVITY

Under normal conditions no hazardous reactions likely.

Stable at ambient temperatures.  Flash point greater than 204°C.                                                                                     

11. TOXICOLOGICAL INFORMATION

Batik Wax  poses virtually no hazard to health when used in normal industrial practice.  There is no hazard from inhalation of the vapour nor is ingestion considered to be a normal industrial hazard.  Wax fumes may cause eye and respiratory tract irritation if present in sufficiently high concentration and in such circumstances efficient localised extraction must be employed.  Skin sensitisation or irritation is very infrequent.

12. ECOLOGICAL INFORMATION

Batik Wax is unlikely to cause any environmental hazards although a spillage of hot wax could produce local scorch damage.  It is expected to be non-toxic to aquatic organisms, fish and mammalian wild life.

13. DISPOSAL CONDITIONS

Disposal considerations must take into account that waxes are generally non-biogradable in the short term.  Non-recoverable waste should be disposed of via a licensed waste contractor.

14. TRANSPORT INFORMATION

Batik Wax in solid form is not classified as hazardous for transport. This product does not require a hazard warning label in accordance with EEC Directives.

15. REGULATORY INFORMATION

Batik Wax is not classified as hazardous for supply under UK CPL or CHIP Regulations.

16. OTHER INFORMATION

The information contained herein is for health and safety guidance only and does not constitute a product specification.  It is, to the best of our knowledge and belief accurate.  However, since the conditions of handling and use are beyond our control, we make no guarantee of results, and assume no liability for damages incurred by use of this material.  It is the responsibility of the user to comply with all applicable laws and regulations.

Colourcraft (C&A) Ltd

Unit 5   555 Carlisle Street East

Sheffield S4 8DT