Brusho Soft Flow Medium

Posted9 January 2023

Updated29 April 2023

Health and Safety Data Sheet – Revised 10/01/2023

1. IDENTIFICATION OF THE SUBSTANCE/PREPARATION AND OF THE COMPANY/UNDERTAKING

Product Name	Brusho Soft Flow Medium
Company Name	Colourcraft Colours & Adhesives Ltd Unit 5 555 Carlisle Street Sheffield S4 8DT
Telephone	0114 242 1431
Fax	0114 243 4844
Emergency	0114 242 1431

2. COMPOSITION/INFORMATION ON INGREDIENTS

Water based synthetic polymer emulsion.

3. HAZARDS IDENTIFICATION

Most Important Hazards	None. Not considered hazardous under normal conditions of use.
Specific Hazards	This product does not present any specific risk.

4. FIRST-AID MEASURES

Inhalation	No appreciable hazard.
Skin Contact	Wash with soap and water.
Eye Contact	Irrigate with water for at least ten minutes. Should irritation occur, seek medical advice.
Ingestion	Wash mouth out with water, give water to drink. Do not induce vomiting. In the unlikely event of sensitivity, seek medical advice .

5. FIRE FIGHTING MEASURES

	Product is not considered a fire hazard.
Fire Extinguishing Media	Suitable: Water, Foam, Dry Powder, CO2 Unsuitable: None.
Personal Protection	Wear self contained breathing apparatus. Wear protective clothing.

6. ACCIDENTAL RELEASE MEASURE

Personal Precautions	Refer to section 8 of HSDS for personal protection details.
Environmental Precautions
Cleaning Measures	Wipe up small spills with a damp cloth. Larger quantities: Absorb with sand or other inert material and place into suitable container for disposal in accordance with local and national regulations.

7. HANDLING & STORAGE

Handling Requirements	No special handling precautions required.
Storage Conditions	Store between 5-25°C. Do not allow to freeze. Keep container closed and out of the reach of young children.
Suitable Packaging	Keep in original packaging.
Additional Information	Handle in accordance with good standards of hygiene and safety practices.

8. EXPOSURE CONTROLS/PERSONAL PROTECTION

General	2
Respiratory	None unless applied by spray.
Hand Protection	Gloves if prolonged skin exposure is anticipated.
Eye Protection	Safety goggles or glasses if risk of product being splashed.
Skin Protection	Working clothes.

9. PHYSICAL & CHEMICAL PROPERTIES

Appearance	Wet: White – Dry: Semi translucent film	Explosive Properties	N/A
Odour	Slight	Oxidising Properties	N/A
pH	4.5-5.5	Vapour Pressure	N/A
Boiling point/range	N/D	Relative Density	0.9-1.1
Melting point/range	N/A	Bulk Density	N/D
Flash Point	N/A	Partition Coefficient	N/A
Flammability	Non-Flammable	Other Data
Auto Flammability	N/A
Solubility	Water: Insoluble but miscible in all proportions.

10. STABILITY AND REACTIVITY

Stability	Stable
Conditions to Avoid	Do not freeze
Materials to Avoid	None
Hazards Decomposition Products	None

11. TOXICOLOGICAL INFORMATION

Acute Oral LD50	No known adverse toxicological effects.
Skin Irritation
Eye irritation

12. ECOLOGICAL INFORMATION

General

No known adverse ecological effects.

13. DISPOSAL

Unused Material

Dispose of small quantities as domestic waste. Large quantities in accordance with regional and national regulations.

14. TRANSPORT INFORMATION

This product is not classified as hazardous for transport under United Nations Transport Recommendations.

15. REGULATORY INFORMATION

Warning Symbols	None
Warning Words	None
Risk Phrases	None
Safety Phrases	None

Note

The regulatory information given above only indicates the principle regulations specifically applicable to the product described in the safety data sheet. The user’s attention is drawn to the possible existence of additional provisions which complete these regulations. Refer to all applicable national, international and local regulations or provisions.